Shell mill holder PSK 63 - 27 - 40Application: For mounting milling cutters with transversal groove. Note: d = 40 d = 60: For large diameter face mill cutters with four additional threaded holes according to DIN 2079. Delivery: With drivers, cross head retaining screw and cylinder head retaining screw for cutters with central coolant. For d = 60 only with four fi xation screws according to DIN 912. All holders are made of forged steel Specific, low warpage hardened Surface hardened

set contains following adaptors:

low warpage hardened

- Integrated pull-down mechanism

bei Ø 6 – Ø 32 mm = h236

Torque range : 20-110 Nm

Ratchet stop

Made of sturdy grey cast iron with hollow profile handles and specially guided prismatic steel jaws

tool steel

Memory : 100 Readings

For use on static and driven toolholders via threaded connector

For mounting milling cutters with transversal groove

Zero-setting at any position