Nozzle Tip (1.5mm)Double bore 1. 5mm x 1. 5mm replacement nozzle tip for the cutting head. The nozzle tip on your FabLight cutting head assembly should be cleaned regularly from molten spatter that occasionally bounces back during the cutting process. The nozzle tip can easily be cleaned with a Scotch Brite pad between jobs, but if there is too much damage or molten material that needs to be removed, you can order this replacement nozzle. Nozzle Tip Retainer Nut sold

X Axis: 2 linear bearings with upgraded K1 seals

Refer to our FreshDesk "Running Beam Centering" article here to perform this verification

Due to supply chain constraints

5" 15 LBS  Insurance recommended

In your FabLight Operator Manual

Flat stainless steel sheet

Replacement ground safety cable to ground the CHS electrical system that allows the cutting head to reference distance for z-axis travel

Replacement 6" SMA-M to SMA-M Right Angle Cable for capacitive height sensor (CHS) assembly

5mm replacement nozzle tip for the cutting head

you can order this replacement nozzle

1 FabClear Pre-Filters are required for operation

The nozzle tip can easily be cleaned with a Scotch-Brite pad between jobs